Problema de configuración ESU V-5 en 319 Startrain
#31
(29-06-2024, 11:44)framauro64 escribió: Importante saber que el decoder de origen, está configurado para que F1,F2,F3,F4,y F5 sea "Aux1","Aux2","vel maniobras", "aceleración y deceleración" y "aux 3"respectivamente y habrá que poner 0 en todas esas variables afectadas para evitar que se maree el deco, jaja. 

Buenas tardes.

Aquí ya me pierdo.

¿Cómo se ponen las funciones a 0?

Saludos.
Responder


Mensajes en este tema
RE: Problema de configuración ESU V-5 en 319 Startrain - por Pedro MT - 29-06-2024, 20:16

Posibles temas similares...
Tema Autor Respuestas Vistas Último mensaje
  Problema con 252 taxi digital Baltek 7 583 10-06-2025, 21:32
Último mensaje: Baltek
  configuración para un Zimo E24 tigrin 9 1,294 05-04-2025, 14:21
Último mensaje: tigrin
  configuración para un Zimo MX618N18 - Next18 tigrin 4 888 18-03-2025, 21:08
Último mensaje: tigrin
  Problema digitalización E10 Cabro 18 2,318 14-03-2025, 17:05
Último mensaje: artinu
  Problema con Zimo MX 616 de cables 8020Javier 62 12,145 08-02-2025, 20:38
Último mensaje: Pedro MT
  Problema digitalizacion locomotora Cabro 45 7,846 29-01-2025, 21:45
Último mensaje: Pedro MT
  Problema Multimaus tigrin 12 2,710 12-12-2024, 15:29
Último mensaje: Pedro MT
  Problema digitalizacion locomotora pequeña Cabro 10 2,470 14-10-2024, 21:14
Último mensaje: Cabro
  Problema Locomotora Digital Dalmon 20 7,106 29-07-2024, 19:32
Último mensaje: tigrin
  Problema multimouse pacman 12 4,090 05-07-2024, 14:54
Último mensaje: Pedro MT

Salto de foro:


Usuarios navegando en este tema: 1 invitado(s)