Decoder Zimo Next 18
#5
Si. Sé que el zimo tiene la función de atenuación de luces, pero no he tenido más tiempo de mirar. Mañana intento echar un vistazo y si veo la configuración te la digo.

Me alegro que te haya funcionado. No se si probaste lo de la velocidad de maniobras, si lo pruebas avisame si te funciona.

Un saludo
Responder


Mensajes en este tema
Decoder Zimo Next 18 - por tigrin - 16-01-2019, 23:16
RE: Decoder Zimo Next 18 - por artinu - 23-01-2019, 22:04
RE: Decoder Zimo Next 18 - por tigrin - 23-01-2019, 22:18
RE: Decoder Zimo Next 18 - por tigrin - 23-01-2019, 23:42
RE: Decoder Zimo Next 18 - por artinu - 24-01-2019, 00:35
RE: Decoder Zimo Next 18 - por artinu - 01-05-2019, 16:02
RE: Decoder Zimo Next 18 - por tigrin - 01-05-2019, 16:15
RE: Decoder Zimo Next 18 - por artinu - 01-05-2019, 17:11
RE: Decoder Zimo Next 18 - por artinu - 26-05-2019, 20:46
RE: Decoder Zimo Next 18 - por Muerto en Vida - 27-05-2019, 13:00
RE: Decoder Zimo Next 18 - por artinu - 27-05-2019, 13:09

Posibles temas similares...
Tema Autor Respuestas Vistas Último mensaje
  configuración para un Zimo E24 tigrin 10 3,247 04-12-2025, 17:50
Último mensaje: Pedro MT
  ¿Que decoder es este? Jorge_ut440 4 649 21-11-2025, 14:53
Último mensaje: Pedro MT
  CV124 decos ZIMO Pedro MT 5 854 30-10-2025, 14:19
Último mensaje: Pedro MT
  CONFIGURACION DECO ZIMO MX618N18 (NEXT 18) 269 ARNOLD emcuadros 9 1,364 27-10-2025, 12:18
Último mensaje: Pedro MT
  Indentificar este decoder JORGITO_YKE 24 11,858 21-10-2025, 09:26
Último mensaje: Pedro MT
  Ayuda para mapear un Zimo next 18 tigrin 16 9,634 28-08-2025, 16:01
Último mensaje: Pedro MT
  configuración para un Zimo MX618N18 - Next18 tigrin 4 2,288 18-03-2025, 21:08
Último mensaje: tigrin
  Problema con Zimo MX 616 de cables 8020Javier 62 21,445 08-02-2025, 20:38
Último mensaje: Pedro MT
  Digitalizar la 277 de Arnold con un decoder Zimo MX618N18 Ozeito 10 10,955 24-11-2024, 21:06
Último mensaje: Pedro MT
Bombilla Encendido lento luces decoder DH18A Pedro MT 10 5,101 15-11-2024, 19:40
Último mensaje: Pedro MT

Salto de foro:


Usuarios navegando en este tema: 1 invitado(s)